Video Steps 30 -31 Disassemble Table Extension & Stadium Ramp Support (Backstop) Bars & Store Accessories

Video Steps 30 -31 Disassemble Table Extension & Stadium Ramp Support (Backstop) Bars & Store Accessories



    • Related Articles

    • Table Extension Support Bars (Steps 30 - 31)

      Step 30 – Disassemble Table Extension & Stadium Ramp Support (Backstop) Bars Using the 6mm (Grey), loosen the hex screws securing the Stadium Ramp Support Bar to the Table Extension Support bars. These are the Hex Screws located below the Stadium ...

    • Stadium Ramp and/or File Platform (Steps 25 - 27)

      The following instructions show the Stadium Ramp however, the instructions are the same for the File Capture Platform with the only variation being the File Capture Platform does not have a handle. Step 25 – Remove Stop Pin from Stadium Ramp & Store ...

    • Table Extensions (Steps 28 - 29)

      Step 28 – Remove Table Extension Fasteners & Support Bar Fasteners Using the 3/16” Hex Key (White) remove the two (2) hex screws securing the table extension to the conveyor section. The Screws securing the table extension can be found in each corner ...

    • Support Brackets and Arm (Steps 35 - 41)

      Step 35 – Place Front Cover on Top of Layer 1 of Foam Packing Tray Retrieve the Front Cover from the Lid. Place the Front Cover on top of the Foam Packing Tray with the latch away from you. Step 36 - Remove the Side-Mounted Support Bracket from the ...

    • Video Step 26 – Remove Stadium Ramp from Table Extension