Table Extension Support Bars (Steps 30 - 31)

Step 30 – Disassemble  Table Extension & Stadium Ramp Support (Backstop) Bars

Using the 6mm (Grey), loosen the hex screws securing the Stadium Ramp Support Bar to the Table Extension Support bars. These are the Hex Screws located below the Stadium Ramp/Backstop Support Bar that secure the receiver to the Table Extension Support Bars. The screw is on top of the receiver. Next, using the same hex key, loosen the Stadium Ramp/Backstop Hex Screws that secures the Stadium Ramp/Backstop Support Bar at the appropriate height. This is the screw on the side of the receiver. Slide the Receivers of the Stadium Ramp/Backstop off the Table Extension Support Bars. Position the receivers so the Stadium Ramp can be stored in Layer 1 of the Foam Packing Tray as shown. Remove the Table Extension Support Bars from the conveyor section and place them in Layer 1 of the Foam Packing Tray as shown.

Step 31 – Store Remaining Accessories

Place the remaining Accessories, ruler and level, in Layer 1 of the Foam Packing Tray as shown. Store the

Ruler

Level

• Related Articles

• Table Extensions (Steps 28 - 29)

  Step 28 – Remove Table Extension Fasteners & Support Bar Fasteners Using the 3/16” Hex Key (White) remove the two (2) hex screws securing the table extension to the conveyor section. The Screws securing the table extension can be found in each corner ...

• Video Steps 30 -31 Disassemble Table Extension & Stadium Ramp Support (Backstop) Bars & Store Accessories

• Video Steps 28 - 29 Remove Table Extension Fasteners, Support Bar Fasteners & Extension

• Support Brackets and Arm (Steps 35 - 41)

  Step 35 – Place Front Cover on Top of Layer 1 of Foam Packing Tray Retrieve the Front Cover from the Lid. Place the Front Cover on top of the Foam Packing Tray with the latch away from you. Step 36 - Remove the Side-Mounted Support Bracket from the ...

• Video Step 26 – Remove Stadium Ramp from Table Extension