Optional Step - Dowel Pin Reassembly
Optional Step - Dowel Pin Reassembly
The Dowel Pin should already be assembled however, if the pin is unscrewed too far it may require reassembly. To reassembly the Dowel Pin, insert the Dowel Pin in the keyhole of the handle. With the Dowel Ping inserted into the handle screw the handle onto the Dual Threaded Flat Head Pin where the Handle Groove Washer is located. Only screw until the handle is secured to the Dual Threaded Flat Head Pin as shown in picture B of below Figure.Related Articles
Video Step 25 – Remove Stop Pin from Stadium Ramp & Store in Tools & Small Parts Box
Monitors (Step 5 - 11)
Step 5 - Get Monitor Storage Case Remove the Monitor Storage Case from the shelves below the main conveyor section. Plate the Monitor Storage Case on top of Layer 2 of the Foam Packing. Remove the cover of the Monitor Storage Compartment. Step 6 - ...Uninstall Document Cameras (Steps 12 -14)
Step 12 – Unplug and pack the Document Camera Cords Unplug the Document Camera Cords from the standard and stadium document cameras. Roll the cords and place them in Layer 2 of the Foam Packing tray with the Main Power and Ethernet Cords. Step 13 – ...Store Accessories in Layer 1 of Foam Packing Tray (Step 24)
Step 24 – Store Accessories in Layer 1 of Foam Packing Tray Retrieve Layer 1 of the Foam Packing Tray from the lid and place on top of Layer 2 on the Main Section of the Conveyor Table. Locate the Accessories no longer needed (Positioning Fence and ...Video Step 32 - Inbound Conveyor Table Section